Thread measurement: pitch diameter, single pitch diameter, major diameter, small diameter, pitch, tooth profile full angle, tooth profile half angle, taper, tooth top arc, tooth bottom arc, tooth top width, tooth bottom width, tooth height, etc., and automatically Discrimination.
With the surface profile measuring instrument as the basic machine, the measurement principle is the same as that of the surface profile measuring instrument, that is, the Cartesian coordinate measurement method is used to map the coordinate points of the surface profile of the measured part through the X-axis and Z-axis sensors, and the electrical components are , transmit the coordinate point data measured by the sensor to the host PC, and the software performs mathematical operations on the collected original coordinate data and marks the required engineering measurement items.
Measurement efficiency: Dedicated thread measurement software, all parameters are automatically calculated, and all results can be calculated in just a few seconds.
Measurement accuracy: Each axis adopts high-precision RENISHAW grating with a resolution of 0.05 and is corrected by laser interferometer to ensure sufficient high-precision original data.
Level of intelligence: All parameters are automatically completed by the computer; the measurement program can be set to automatically measure.
Convenience: The measured upper and lower edge graphics and parameters are all reflected in one report.
Measuring range: The thread length that can be measured at one time is 120mm.
Cost-effectiveness: The thread database is subdivided into modular units by type, which can be equipped on demand to save costs.
Cylindrical thread ring gauge: inner diameter ≥ 16mm, tooth half angle ≥ 27°
Medium diameter: ±(5+6H/60)μm
Small diameter: ±(5+6H/60)μm
Pitch: ±(1.5+2H/4)μm
